If you are experiencing difficulty with your Kilburn II not turning on, the likely cause is that the battery is discharged.
Connect the power cord to the Kilburn II and a working wall socket.
Waking the device from standby mode
If Kilburn II goes to sleep (Standby mode), you need to wake up the device by following these steps.
1. Insert the AC cable into the back of the speaker and the AC plug (2 pins) into the home power supply socket 100-240 VAC (50/60Hz).
2. Turn the ON/OFF knob to level 5.
3. Press and hold the Bluetooth button for about 1 minute.
4. After 1 minute, release the Bluetooth button. You will hear a notification sound and the battery status LED (right-hand side) will move up and down continuously.
5. After that, press and hold the Bluetooth button for 2-3 seconds to connect the Bluetooth signal to the smart phone device again.
Note for use :
- Make sure the battery is fully charged. Before use
- Avoid charging the battery and play music at the same time.
- Avoid use for long periods of time. Until the battery is low or exhausted.
- If the battery power level is 3-2-1, there will be a sound notification (1-2 times).
- Should stop playing music for 5-10 minutes before starting to charge the battery again. This will ensure that the battery has cooled down and to preserve the battery for longer use